产品中心
产品展示

  您当前的位置:首页 » 产品展示 » 专用仪器仪表 » MHY-13874石油产品水银温度计,玻璃温度计 厂家

产品名称: MHY-13874石油产品水银温度计,玻璃温度计 厂家
产品型号: MHY-13874
品牌: 623
产品数量:
产品单价: 面议
日期: 2024-04-17

MHY-13874石油产品水银温度计,玻璃温度计 厂家的详细资料

 1:石油产品水银温度计/玻璃温度计
型号:MHY-13874

度:0.1
测量范围:180-230度
规格:大约450mm*7mm

2:电源适配器
  型号;MHY-20118

详细介绍:
Model MHY-20118
DC Output
(O/P) DC voltage 12V
Rated current
Current range 0~
Ripple & Noise (max) 120mVp-p
Rated power 60W
Voltage tolerance ±5.0%
Setup, rising time 500ms, 50ms at full load
Hold up time >5ms at full load
Input
(I/P) Rated Voltage range 90~264VAC
  100-240Vac          
Frequency range 47~63Hz
Efficiency (average) >84% (min)
AC current 1.3A(max)
Leakage current < 0,25 mA at 250 V
Inrush current < 60 A at 230 V
Protection Short circuit type Hiccup mode , but can\'t damage for permanent short circiut.
Over voltage type 115~150% rated voltage and Shut off O/P voltage, re-power on to recover
Over load type 115~200% rated output power and Hiccup model, no damage, automatic recover after removing over load condition
Environment Working temp 0 ~+40℃
Working humidity 20 ~90% RH non-condensing
Storage temp & humidity -20~+85℃, 10~95% RH
Vibration EN 61131-2
Safty & EMC Standards design refer to EN60950
Withstand voltage I/P-O/P: 3KVAC, 5mA, 60S ( 2pin); I/P-O/P: 1.5KVAC, 5mA, 60S (3pin); 
Isolation resistance I/P-O/P: 100M ohms/500VDC
EMC EN55022 Class B
Others Certification N/A
MTBF 300 Khrs, Mil-HDBK-217F(25℃)
Connection 2pin plug or 3pin; H03VV-F 0.75mm²x2 wires
Dimension 128*68*45mm (L*W*H)
Weight 650g 
IP rating IP67
RoHS compliance Yes
Warranty Period 2 year
Note: 1. All parameters NOT specially mentioned are measured at 230VAC input and rated load and 25℃ of ambient temperature.
2. Ripple & Noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3:裂缝宽度观测仪/裂缝宽度测量仪/裂缝观测仪
 型号:MHY-20116


应用域


桥梁、隧道、墙体、混凝土路面、金属表面等裂缝宽度的定量检测。
2.性能特点


采用现代电子成像术,将被测结构裂缝原貌成像于主机显示屏幕上,通过屏幕上激光刻度尺,读出真实可靠的裂缝宽度数据。
依据标准

中华人民共和《房屋安鉴定标准》-----  GJ125-99
术参数:

放大倍数:40倍

测量范围:0.01mm~2.00mm或3.00mm

屏幕刻度:0.01mm

估测度:0.005mm

供电方式:电锂电池,连续作时间5小时

整机尺寸:134mm×95mm×36mm

显微测量传感器:34mm×36mm×46mm

显示屏重量:600g

传感器重量:60g